物理概念与数学运算

在解物理题时，物理概念与数学运算有着十分密切的关系．合理运用物理概念能使数学运算简单明了，恰当的数学运算又能促进对物理概念的理解．但是，过分地强调使用数学运算方法，而忽视物理概念，有时会带来麻烦的计算，使简单的问题数学运算复杂化．下面我们看一个简单而著名的例子．     

Characterizations of Tb:Zn2SiO4 films on silicon wafer prepared by sol-gel dip-coating and solid-phase reaction

Terbium-doped Zn_2SiO_4 films were successfully prepared on Si wafers by a simple sol-gel dip-coating and solid-phase reaction method of ZnO and SiO_2. X-ray diffraction (XRD) and UV－Vis absorption results revealed that films processed below 850℃ were ZnO in wurzite structure, and films processed above 850℃ were Zn_2SiO_4 in wellimite structure. Photoluminescence measurements of the Tb-doped Zn_2SiO_4 films showed two strong emission bands at 490 and 545nm. The photoluminescence lifetime was 4.6ms.     

光突发交换的交换控制策略和光缓存配置

光突发交换是面向下一代互联网的光交换模式.讨论了异步光突发交换系统的交换控制策略以及相应光缓存的优化配置策略.除了传统预约模式的交换策略,还研究了非预约和改进型预约模式,它们的性能评估由计算机仿真给出.结果表明:在条件相当情况下,改进型预约模式具有最低的丢包率.同时光缓存的配置对上述几类交换控制策略的性能都有很大影响,仿真结果指出:光缓存的粒度对系统性能具有重要影响,所讨论的几类交换模式都存在最佳时延粒度,研究结果对光交换矩阵的设计有指导意义.     

Living/controlled radical copolymerization of N‐substituted maleimides with styrene in 1‐butyl‐3‐methylimidazolium hexafluorophosphate and anisole

The atom transfer radical copolymerization of N‐substituted maleimides such as N‐phenylmaleimide (PhMI), N‐cyclohexylmaleimide (ChMI), and N‐butylmaleimide (NBMI) with styrene initiated with dendritic polyarylether 2‐bromoisobutyrates in an ionic liquid, 1‐butyl‐3‐methylimidazolium hexafluorophosphate ([bmim][PF₆]), at room temperature and anisole at 110 °C was investigated. The dendritic‐linear block copolymers obtained in ionic liquid possessed well‐defined molecular weight and low polydispersity (1.05 < M_w/M_n < 1.32) and could be used as a macroinitiator for chain‐extension polymerization, suggesting the living nature of the reaction system. The ionic liquids containing catalyst could be recycled in the atom transfer radical polymerization systems without further treatment. Compared with polymerization conducted in anisole, the polymerization in ionic liquid had a stronger tendency for alternation. The tendency for alternation decreased in the order PhMI > NBMI > ChMI in [bmim][PF₆] and PhMI > ChMI > NBMI in anisole. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2156–2165, 2003     

利用场发射显微镜研究O2对单壁碳纳米管场发射的影响

利用场发射显微镜和四极质谱计研究了充入高纯O2的四极质谱和O2对单壁碳纳米管场发射的影响.单壁碳纳米管经过约1000℃的热处理得到清洁态场发射像后，充入O2，分别测量了O2吸附和脱附后场发射的I V特性.实验观测到在单壁碳纳米管上O2的吸附使场发射电流减小，说明逸出功增加.在10-4Pa的O2压强下对单壁碳纳米管进行约1000℃的热处理，可以产生氧化刻蚀作用，观测到场发射像的变化，并测量了氧化刻蚀产生的I V特性变化. 关键词： 单壁碳纳米管 场发射显微镜 场发射 四极质谱     

大口径光束波前采样器(孔栅)的研制

应用平面波角谱理论，分析了采样器对光波场采样和分光的基本原理以及对空间采样频率的选择规则，描述了实际研制的大口径采样器的结构设计，并通过数值方法和高能激光大气传输实验研究了高能激光经采样器前／后的远场光斑分布关系。结果表明：利用光束波前采样器能高保真地实现对高能激光束的分光。     

129Xe30+轰击Ni表面激发靶原子偶极跃迁和禁戒 (M1和E2)跃迁的特征光谱线

报道了用高电荷态离子129Xe30+(150keV) 轰击金属Ni表面，激发的200—1000nm NiⅠ和NiⅡ的特征光谱线的实验结果.实验结果表明：用电荷态足够高的离子作光谱 激发源，无需很强的束流强度（nA量级），便可有效地产生原子和离子的复杂组态间跃迁所 形成的可见光波段的特征谱线，特别是NiⅠ和NiⅡ偶极禁戒的电四极跃迁E2和磁偶极跃迁M1 的特征光谱线.通过分析发现，在禁戒跃迁的谱线中，有些是电子组态相同而原子态不同的 偶极禁戒跃迁光谱线而且NiⅡ的684.84nm谱线较强. 关键词： 光谱 禁戒跃迁 电子组态 高电荷态离子     

Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)     

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Influence of solvents on the formation of ultrathin uniform poly(vinyl pyrrolidone) nanofibers with electrospinning

Although there have been many reports on the preparation and applications of various polymer nanofibers with the electrospinning technique, the understanding of synthetic parameters in electrospinning remains limited. In this article, we investigate experimentally the influence of solvents on the morphology of the poly(vinyl pyrrolidone) (PVP) micro/nanofibers prepared by electrospinning PVP solution in different solvents, including ethanol, dichloromethane (MC) and N,N‐dimethylformamide (DMF). Using 4 wt % PVP solutions, the PVP fibers prepared from MC and DMF solvents had a shape like a bead‐on‐a‐string. In contrast, smooth PVP nanofibers were obtained with ethanol as a solvent although the size distribution of the fibers was somewhat broadened. In an effort to prepare PVP nanofibers with small diameters and narrow size distributions, we developed a strategy of using mixed solvents. The experimental results showed that when the ratio of DMF to ethanol was 50:50 (w/w), regular cylindrical PVP nanofibers with a diameter of 20 nm were successfully prepared. The formation of these thinnest nanofibers could be attributed to the combined effects of ethanol and DMF solvents that optimize the solution viscosity and charge density of the polymer jet. In addition, an interesting helical‐shaped fiber was obtained from 20 wt % PVP solution in a 50:50 (w/w) mixed ethanol/DMF solvent. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3721–3726, 2004